I have 4 visors here, and would like a set recovered, you can keep the extra set. I have a HomeLink cluster I would like installed in the drivers one. It is for opening garage doors, turning on lights in the house ect.
This is what the module looks like:
It is about 1/2" thick.
Here is what it looks like in a set of visors:
Is this something you think you can do? I am not worried about the visor being a little bit thicker really. If so, what would you charge for this? Thanks!
I am up for the challange. I will pm you later on this.
quote
Originally posted by JohnWPB:
I have 4 visors here, and would like a set recovered, you can keep the extra set. I have a HomeLink cluster I would like installed in the drivers one. It is for opening garage doors, turning on lights in the house ect.
This is what the module looks like:
It is about 1/2" thick.
Here is what it looks like in a set of visors:
Is this something you think you can do? I am not worried about the visor being a little bit thicker really. If so, what would you charge for this? Thanks!
Sounds good. Can you do the piping and the Fiero logo, like I have seen on many of the visors, in "Electric Blue"? It is the color of my 2-tone seats from Mr. Mike, as well as the stitching on my door panels.
The piping I am referring to is like this, but in Electric Blue:
And I would like the Fiero logo in the electric blue thread as well.
If you are not able to get the piping in the blue that Mr. Mike uses, I can purchase some from him, and send it along with the visors.
[This message has been edited by JohnWPB (edited 08-07-2011).]
Ok, will give Mike a call then. If you don't mind, can you give me a ring on my cell phone? I have a couple of questions and need to toos some ideas back and forth. five 6 1 two three six 7 O 2 four. Thanks!
