quote Originally posted by TONY_C: You need to get an 84 factory service manual and find a rear harness from an 84. the wiring for 84s are unique and the other years don't interchange. The location of the C500 connector is also unique to the 84, the other years have it close to the battery.

Get the service manual on CD from TFS and put it together piece by piece.

quote Originally posted by 85 SE VIN 9: 1. Summit Racing has seats and brackets. They're not Fiero and don't have speakers, but they look like decent replacements. Speakers can be found at TFS and on ebay, Mr. Mike's web site explains how to replace or retrofit them. 2. 3800 SC. Phondawgz wiring harness. 4. There is a long saga of a thread about a guy who designed a nice panel for the Vette lights, then died. People have tried and tried to get someone to use his molds, etc., but calls are not returned and so on.

Do you have a link? I have vette lights laying around I have no plan to use.

I saw that panel. A waste that we won't see it again. It looks amazing. I found my seats a set from an 85 for 75 in good shape

(oval) Vette lights panel: https://www.fiero.nl/forum/Forum2/HTML/123873.html

Seat brackets: http://www.summitracing.com...4951090%204294949996

Procar seat, not sure it fits, $170: http://www.summitracing.com/parts/sca-80-1606-61l

Haven't located the cheap racing seats this time and computer crashed twice since I saved them.

[This message has been edited by 85 SE VIN 9 (edited 08-14-2014).]

i am selling some parts from my car to pay for my motor swap. i can get the complete 3.4 for 200. what else is needed to swap it into a 84? i have a 4spd. i will be doing carbed not injected. as well as custom gauges. what parts will i need to buy. here is my parts list so far.

2.8 water pump
2.8 oil pan
2.8 timing cover.
plugs
wires
new starter
new clutch
fluids
motor

Different or mechanical fuel pump

Exhaust

Carb and intake manifold

Radiator hoses and pipe?

Are you going to rebuild the 3.4?

Mounts

Cradle?

Much of this is because there was no 2.8 in '84, so it's not as straightforward as replacing a 2.8 with a very similar 3.4. Am I right? Did I miss something?

quote Originally posted by concorde01: ok vin decoder says it is a 1984 Pontiac Fiero 2dr Coupe SE Sport 4-Spd

[This message has been edited by 85 SE VIN 9 (edited 08-14-2014).]

ok so i pulled the whole back off my car. had been repaired twice looked to have been broke in half. whil it is off i will be putting in a 85 light harness followed by new rear skin. and bumper for dual exhaust pics to come soon