quote Originally posted by racer37: Hey Rob, I've got the front wiring harness down here out the 86 SE if ya'll need it. I dont think it has been butchered....... Do you have any 87 or 88 columns, I need the cruise staulk with the wires. Scott

I've got one that's not butchered, I'm hunting one that is already butchered. No 87 or 88 columns or parts at all, just 84 and 86.

But I am not going to use this one, I replaced it with an 87 harness.

Do you have a nice left taillight for an 88 notchback? Thanks

------------------
88 Formula, Stock T-Tops, 4spd/auto, 3.2 V6, balanced, 9.5 comp ratio, roller chain, roller tip rockers, H260 cam, Darrell Morse throttle body, GSXRBOBBY Corvette brakes, 17lb injectors, Trueleo intake, Spintech muffler, K&N ,

Are you guys planning on bringing parts to the Swap Meet at the Fiero Factory in late April?

quote Originally posted by sjmaye: Are you guys planning on bringing parts to the Swap Meet at the Fiero Factory in late April?

i think robs takeing a van load of stuff

Maybe let me check today.

i need a center console . would like to find complete in grey. but could get by with just the shifter surround in black.i have the trim plate, but the surround is no good. thanks
drake

quote Originally posted by 86blackse: i sold the last set i had,,,, rob you got one?

I got 1 left one that has a small crack in the top. Hey Scott have you got a good left tail light?

quote Originally posted by 86blackse: i think robs takeing a van load of stuff

Looking for the insulation that goes on the passenger side only of the engine compartment. Don't need anything from the firewall. I need it uncut and in good conidtion. I don't know if they are different, but my car is a 1988GT.

If you have such, how much if I pickup in Toney AL Swap Meet

Let me check for the taillight, I think I do.

Bump for the weekend to remove parts.

Rob- Did you happen to find any of that insulation I mentioned above?

I need a rounded passenger front side marker light. let me know if you have one.

Do you have a shifter console and radio faceplate in good condition? I know i asked awhile ago but im still searching and i was hoping youd have them now. Thanks!

Rob or Gary, I'm still waiting for the two AC relays and the wire and plug for them them. This will let me finish my AC install and let me charge my AC system. It was 86 here in Texas today.
Joe Crawford
Texas

Hey Rob, how much for a pair of power side mirrors(They don't have to look good, but they need to work). I can pick them up at the swap meet. also, do you have any 88 parts?

Tom

[This message has been edited by carnut122 (edited 04-08-2008).]

quote Originally posted by sjmaye: Rob- Did you happen to find any of that insulation I mentioned above?

All the insulation is gone or shreaded.

quote Originally posted by josef644: Rob or Gary, I'm still waiting for the two AC relays and the wire and plug for them them. This will let me finish my AC install and let me charge my AC system. It was 86 here in Texas today. Joe Crawford Texas

Joe I'll try and get them out and down to Gary for shipping this weekend.

quote Originally posted by Robs Fieros: Joe I'll try and get them out and down to Gary for shipping this weekend.

Thanks Rob
Joe

I'm in the need for a set of 84 quarter windows with no "se" on them. They must be the glass ones please.

Thanks!

------------------



1999 GMC Jimmy 2dr 4x4
1988 Fiero Formula-For Sale
1985 Fiero GT 3800 N/A-soon to be 3800S/C
1984 Fiero Indy

Top 'O The Week Bump Fer Ya

Gary did my parts make it there this weekend?
Joe

i dont have any joe,,,i think rob got them pulled today

[This message has been edited by 86blackse (edited 04-14-2008).]

Hi there,
Do you have a good working TPS (throttle position sensor) for a '86 V6? How about a full power mirrors kit?

i sure do,, do you need mirrors, switches and all??

Yes, switches, mirrors, wiring harness, the whole thing. I don't have any ofit on my car; just the manual mirrors. Not even the rubber bellows between the doors and the body.

Also, do you have a good TPS?

What kind of price( if you have one ) on a gt tail light LHS( "PON" ) shipped to 75024?

quote Originally posted by ktthecarguy: Yes, switches, mirrors, wiring harness, the whole thing. I don't have any ofit on my car; just the manual mirrors. Not even the rubber bellows between the doors and the body. Also, do you have a good TPS?

i have every thing here,, i do have a tps sensor also

How about an ECM Mounting tray for an 87/88 4 cylinder, to 97006.


Thanks

Rich

all i have left its a 85gt v6,,,sorry

thanks anyway


Rich

Looking for front/rear bumpers and side moulding from a late model notchback. Commonly called the coupe bumpers. Will purchase or trade for my complete '86 GT setup (front/rear bumpers and GFX). Located in Lethbridge, Alberta

I could use an el cheapo grande right hand wing stanchion... got one?