Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  3800 Flywheel bolt recommendations (Page 2)

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version

This topic is 2 pages long:  1   2 
Previous Page | Next Page
3800 Flywheel bolt recommendations by Dennis LaGrua
Started on: 05-31-2008 02:56 PM
Replies: 41
Last post by: IXSLR8 on 09-13-2008 02:50 AM
Fie Ro
Member
Posts: 3735
From: Soest, The Netherlands
Registered: Sep 2001

Feedback score: N/A
Leave feedback





Total ratings: 132
Rate this member
Report this Post09-12-2008 02:46 PM Click Here to See the Profile for Fie RoSend a Private Message to Fie RoDirect Link to This Post
Thanks for the clarification Dave !

To prevent shockload from the flywheel to the bolts at startup you may turn the flywheel opposite of the turning direction to take out any slack and then bolt it down..
to 19 ft. lbs. I guess
IP: Logged
IXSLR8
Member
Posts: 674
From: Post Falls, ID, USA
Registered: Sep 2004

Feedback score: (1)
Leave feedback

Rate this member
Report this Post09-13-2008 02:50 AM Click Here to See the Profile for IXSLR8Send a Private Message to IXSLR8Direct Link to This Post
No problem.

Fieros are funner when you can drive them, eh! LOL!
I need to get my N* swap done. I'm so close.
IP: Logged
Previous Page | Next Page

This topic is 2 pages long:  1   2 

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock