Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Changing Fuel Pumps

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Changing Fuel Pumps by joshuaz99
Started on: 01-02-2005 08:04 PM
Replies: 3
Last post by: joshuaz99 on 01-02-2005 10:46 PM
joshuaz99
Member
Posts: 140
From: Chesapeake, VA
Registered: Apr 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post01-02-2005 08:04 PM Click Here to See the Profile for joshuaz99Send a Private Message to joshuaz99Direct Link to This Post
I am currently in the middle of my 3.4 swap and my new V6 AC DELCO
fuel pump should be here tomorrow. The thing I am curious of is the donor
is a 1984 4 cyl. I have read that these dont have pulsators. Who knows what
else they didnt have compared to other years.LOL Can anyone tell me what
else I will need in order to complete this portion of my task. I am getting a new
strainer for sure, but is that all I need? Thanks a lot. Joshua
IP: Logged
PFF
System Bot
rvalmore
Member
Posts: 649
From: Saratoga,ny
Registered: Jul 2003


Feedback score: (2)
Leave feedback

Rate this member

Report this Post01-02-2005 08:09 PM Click Here to See the Profile for rvalmoreSend a Private Message to rvalmoreDirect Link to This Post
I was just researching this myself here are a few links for you.

https://www.fiero.nl/forum/Archives/Archive-000001/HTML/20030531-2-032226.html

https://www.fiero.nl/forum/Archives/Archive-000001/HTML/20010824-2-007784.html
hope this helps.

------------------

3100 swap in progress

[This message has been edited by rvalmore (edited 01-02-2005).]

IP: Logged
paulcal
Member
Posts: 2608
From: Jacksonville, Fl
Registered: Oct 2002


Feedback score: (1)
Leave feedback





Total ratings: 96
Rate this member

Report this Post01-02-2005 09:15 PM Click Here to See the Profile for paulcalSend a Private Message to paulcalDirect Link to This Post
You may need a soldering iron. I just did mine the day before yesterday and my ground wire on the pump is soldered/welded to one of the tubes. You just have to cut the connector off the wire and solder it to the new wire. Plan on about 3hours to do the job.

------------------

AIM-jaxpac257
Fear is not an admission of weakness;
fear is an opportunity for courage.

IP: Logged
joshuaz99
Member
Posts: 140
From: Chesapeake, VA
Registered: Apr 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post01-02-2005 10:46 PM Click Here to See the Profile for joshuaz99Send a Private Message to joshuaz99Direct Link to This Post
Thanks for the replies guys. +s for you.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock