I need an 88 cradle, any condition. Northeast location preferred.

Or: Need to borrow/rent one for a few months in order to move a roller 88 car into storage and later out of storage after a few months.

------------------
88GT 355 CI, AED HO 750 Double Pumper, AFR milled 180, Dyno'd at 427 HP, 360 WHP, F40 6-Spd
anderson@gdsconsulting.com

[This message has been edited by V8Steve (edited 12-20-2025).]

I made a roller dolly.Four wheels from harber frieght and four pieces of 2x3 steel tubeing.

We had fabricated dollies (front and rear) for moving cars as well.

We used large diameter pneumatic tire casters so we could go on and off the trailer, or on unpaved surfaces.

Inexpensive and worked well.

By the way all Fiero rear subframes are interchangable,,,, that is they all bolt up to the same holes.

quote Originally posted by thelinsells: By the way all Fiero rear subframes are interchangable,,,, that is they all bolt up to the same holes.

except the struts are different

Thanks to everyone for the ideas. I'm moving and need to first store the Alden Thomas GTO on one place and later to another. As a roller it will simply be much easier to move around.

The LS3 is already mounted on the modified powder coated cradle. I'm going to remove the LS3 and F40 and then reinstall the cradle alone. This will allow me to attached the wheels, struts, etc. The axles will be suspended by slings.

Thanks everyone.

------------------
88GT 355 CI, AED HO 750 Double Pumper, AFR milled 180, Dyno'd at 427 HP, 360 WHP, F40 6-Spd
anderson@gdsconsulting.com