Up for sale is a complete set of molds to produce my car, I designed and built this car over the last 8 years. I believe there are enough differences in my design that big red can’t say it theirs.

I was going to produce and sell roller cars with the bodies already mounted but I turn 72 this month and I just don’t have the drive.

I’m asking $20,000 for the set of molds the buyer is responsible to for any costs in shipping. They are well built quality molds that I used to pull the body panels to produce this car. They have wide flanges to allow for carbon fiber infusion to produce CF bodies.
It comes with a rotisserie mobile mount that I designed to facilitate ease laying up the rear body half.
There are approximately 20 mold parts that make up the body panels.

Here are a few specs of the finished car compared to the GTO
My car was built was built on a unstretched 93.5” Fiero frame vs 96.5 OEM GTO
My car is 173” long vs 169” OEM GTO
My car is 78” wide vs 75” OEM GTO it does require a widened suspension.
I believe the body could be attached to other mid engine donor cars with some fabrication and mods.

I will work with the buyer to help facilitate the shipping.
If your interested in the molds please message me and we can forward contact information.
Thanks for looking
Wayne






I pulled the first set of panels from my molds and built this car.

I usually dislike any of the rebodies I have seen, however this looks great! Is that your red car in the pics then?

quote Originally posted by Spadesluck: I usually dislike any of the rebodies I have seen, however this looks great! Is that your red car in the pics then?

Yes it was built using the fiberglass panels I layed up in the molds.
The full build for the car is in the Construction Zone 288 GTO build.
Thanks for the compliment!!
Wayne