Pennock's Fiero Forum
  The Mall
  EXHAUST FLANG

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
EXHAUST FLANG by thelinsells
Started on: 05-02-2021 02:46 PM
Replies: 1 (92 views)
Last post by: thelinsells on 05-15-2021 10:56 AM
thelinsells
Member
Posts: 448
From: gainesville florida alachua
Registered: May 2014


Feedback score: (3)
Leave feedback

Rate this member

Report this Post05-02-2021 02:46 PM Click Here to See the Profile for thelinsellsClick Here to Email thelinsellsSend a Private Message to thelinsellsEdit/Delete MessageReply w/QuoteDirect Link to This Post
This exhaust flang is for making an exhaust system bolt up to a Soltice exhaust manifold with an Ecotek GM motor.If you are going to do the swap ,and make your own pipes this flang will save you a lot of work. It allows for a good fit from the 2 1/2 inch manifold outlet hole to the 2 1/2 inch pipe.Machined out of 1/4 inch plate to give plenty of room for final surfacing.
IP: Logged
PFF
System Bot
thelinsells
Member
Posts: 448
From: gainesville florida alachua
Registered: May 2014


Feedback score: (3)
Leave feedback

Rate this member

Report this Post05-15-2021 10:56 AM Click Here to See the Profile for thelinsellsClick Here to Email thelinsellsSend a Private Message to thelinsellsEdit/Delete MessageReply w/QuoteDirect Link to This Post
I am now working on the flang that bolt to the haed.The last time I looked someone sold this item for like $150.My idea is to sell it for about $50.This will allow making your own headers and your own exhaust system.
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock