The tranny mount brackets from the 92 to 96 Trans Sport or lumina vans that had the 4T60E tranny bolt up to the early 4T65E trannies and work with the stock Fiero rubber mounts. Two new mounting holes have to be drilled into the rear tranny mount point on the cradle which is very easy to do then all that is needed is a matching engine mount and you are done mounting wise.
For the later 4T65E trannies that do not have the mounting bosses on the rear side of the tranny an adapter plate is also easy to make to still use the van bracket as well. Dan
------------------
DARN Cars now open with
Over 30 years wiring experience between cars and trade as an avionics technician in both Canadian Air Force and civilian aviation.
Over 25 years experience building and modifying cars.
Over 10 years of full Fiero engine swaps and harnesses building and still going.
