Howdy ladys and gents, a minor inconvenience; I am here to tell you that after driving 20 minutes to Auto zone to rent the "OEM steering wheel puller", it does not come with the proper size bolts to extract the wheel in our Fiero... So now I am now going to go on an epic quest to Lowes to try to find the proper size!

If anyone has any information on what thread pitch/size of the two little bolt holes that are used to anchor the extractor to the steering wheel, please post it up!

------------------
"Discord"
Red 1988 GT under restoration!

Let's Go Mets!

( ͡° ͜ʖ ͡°)

The answer is 5/16 - 18 bolts. I got the 4 inch version.

------------------
"Discord"
Red 1988 GT under restoration!

Let's Go Mets!

( ͡° ͜ʖ ͡°)

Note: Many OEM Steering wheels and Columns have a mix of Metric and SAE parts...
Tilt pivots are another one uses SAE puller thread.

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)

The Ogre's Fiero Cave (It's also at the top and bottom of every forum page...)