A while back I put 190mph gauges on my Fiero, and bought a crystal to fix the error. However I got lazy and never bothered to install the crystal. Can anyone tell me how this is done? Like where it goes? Pictures would be amazing.

Thank you!

I found a website that gives the formula 534/max speed = MHz crystal needed. So 534/190 gives 2.81. I forgot what MHz crystal I bought, but I did the calculations when I bought it so it should be right.

I'm sure there's pics in the archives and you'll need a soldering iron and solder. Shouldn't be too hard of a job. If you never soldered before you may want to find someone who has. Wouldn't want to mess up a good board.

Beware of friends bearing blow-torches!

Spoon

------------------
"Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut

Beware of Friends bearing Fieros with 190mph speedos.