Pennock's Fiero Forum
  Technical Discussion & Questions
  Calling all Quad 4 gurus

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
Calling all Quad 4 gurus by Hulk
Started on: 02-09-2014 08:09 PM
Replies: 2 (190 views)
Last post by: Hulk on 02-10-2014 02:19 AM
Hulk
Member
Posts: 615
From:
Registered: Oct 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-09-2014 08:09 PM Click Here to See the Profile for HulkSend a Private Message to HulkEdit/Delete MessageReply w/QuoteDirect Link to This Post
My wife's car is a 95 Grand Am. I just got done rebuilding the engine, and I'm reinstalling it. I cannot find ANYWHERE the exhaust flange gasket (donut). On this car the inner sleeve extends about 1/2" out of the flat side of the donut. The other side is obviously rounded for the flanged exhaust pipe. The ID is around 41mm (1.625" or 1 5/8").

Does anyone know where I can find this gasket? Thanks in advance!

Ryan
IP: Logged
PFF
System Bot
Spoon
Member
Posts: 3762
From: Sadsburyville, PA. 19369 / USA
Registered: May 2004


Feedback score:    (16)
Leave feedback





Total ratings: 61
Rate this member

Report this Post02-09-2014 08:56 PM Click Here to See the Profile for SpoonSend a Private Message to SpoonEdit/Delete MessageReply w/QuoteDirect Link to This Post
Rockauto.com??

Spoon

------------------
"Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut

IP: Logged
Hulk
Member
Posts: 615
From:
Registered: Oct 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-10-2014 02:19 AM Click Here to See the Profile for HulkSend a Private Message to HulkEdit/Delete MessageReply w/QuoteDirect Link to This Post
Thank you. I do buy from RockAuto often. But, I made a mistake in measuring. Good thing I didn't have anything to cut, huh? Anyway, the correct ID is 2 3/32" or 53mm. I guess sometimes I have to make a fool of myself on here before I realize what I did wrong. smh
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock