Thru the years I have seen more than a few looking for good used manual shift cable retainer clips. Seems they are hard to find. I had this idea to make these for a while now. I finally got around to having some made:

http://rodneydickman.com/ca...h=57&products_id=357

------------------
Rodney Dickman

Fiero Parts And Acc's Web Page:
All new web page!:www.rodneydickman.com
Rodney Dickman's Fiero accessories
7604 Treeview Drive
Caledonia, WI 53108
Phone/Fax (262) 835-9575

Good job Rodney!

Rodney, how thick is the steel on this clip?? 1/16s??

------------------

fierogt28

88 GT, Loaded, 5-speed.
88 GT, 5-speed. Beechwood interior, All original.

I can believe it is hard. 12 years ago, a guy at a store went brake part hunting to find me one. I suspect not many places will pull a component from an assembly like he did. Wish I still had that car.

So how many clips are required to replace them all on a 4-speed?

Spoon

------------------
"Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut

quote Originally posted by Spoon: So how many clips are required to replace them all on a 4-speed? Spoon

4

Thank you! I was incredibly nervous about losing my clips during my engine swap after reading that they are incredibly difficult to find.