Pennock's Fiero Forum
  General Fiero Chat
  brake master cylinder seal kit

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
brake master cylinder seal kit by jon m
Started on: 09-29-2013 12:10 PM
Replies: 3 (623 views)
Last post by: theogre on 09-29-2013 06:51 PM
jon m
Member
Posts: 1192
From: ENGLAND
Registered: Apr 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post09-29-2013 12:10 PM Click Here to See the Profile for jon mSend a Private Message to jon mEdit/Delete MessageReply w/QuoteDirect Link to This Post
Hi - long story short (hopefully) - a couple of years back when I was putting my 87 gt back together I had a problem with bleeding the brakes - turned out with the help of members on here that it was the master cylinder.
so I ordered a rebuilt master cylinder.
due to shipping costs I kept my old one.

does anybody know if I can get a rebuild kit for it so that I have a spare "ready to go" on the shelf.

any opinions are always welcome

jon
IP: Logged
PFF
System Bot
RWDPLZ
Member
Posts: 15050
From: Michigan
Registered: May 2002


Feedback score:    (11)
Leave feedback





Total ratings: 305
Rate this member

Report this Post09-29-2013 12:37 PM Click Here to See the Profile for RWDPLZClick Here to visit RWDPLZ's HomePageSend a Private Message to RWDPLZEdit/Delete MessageReply w/QuoteDirect Link to This Post
AC Delco makes one, easy to install, only hard part is prying the c-clip out. AC Delco 18G1276, or GM 19114045, $24 + shipping on Rock Auto
IP: Logged
jon m
Member
Posts: 1192
From: ENGLAND
Registered: Apr 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post09-29-2013 12:39 PM Click Here to See the Profile for jon mSend a Private Message to jon mEdit/Delete MessageReply w/QuoteDirect Link to This Post
Thanks RWDPLZ for a quick reply

jon
IP: Logged
theogre
Member
Posts: 32520
From: USA
Registered: Mar 99


Feedback score: N/A
Leave feedback





Total ratings: 572
Rate this member

Report this Post09-29-2013 06:51 PM Click Here to See the Profile for theogreClick Here to visit theogre's HomePageSend a Private Message to theogreEdit/Delete MessageReply w/QuoteDirect Link to This Post
Many seals fail because the MC Bore(s) are bad and eat the seals.
Fiero MC is quick take-up design...
QT valve is not available in a "rebuild" kit.
"Honing" aluminum MC is very hard for DIY jobs.

See my Cave, Brake Service and Quick Take-up notes

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)


The Ogre's Fiero Cave (It's also at the top and bottom of every forum page...)

IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock