Yes it is true I have been working on a new version on the spare tire cover. Much bigger print and This version is going to ROCK. I will be working on it tonight and I will have a sample to show you by the end of this week.
Here's a thought; put two "button holes" in them so the hold-down rod can be run thru inside so it is not covering the logo.
Jonathan
That sounds like a pain in the ass to get it on and off, how about you paint your rod to match the emblem!!! But of course....I can't remember the last time I used a spare tire...
[This message has been edited by DLCLK87GT (edited 09-29-2013).]
That sounds like a pain in the ass to get it on and off, how about you paint your rod to match the emblem!!! But of course....I can't remember the last time I used a spare tire...
1. Remove screw-on holder. 2. Raise hold-down rod. 3. Slide tire cover onto the rod. 4. Re-secure the rod with the holder as before. 5. Adjust the elastic skirt of the cover around the spare.
Looks good, the one I have is your older ones that are stitched, what material are these emblems?
Thank You
These are vinyl that is heat pressed into the material. It will not peal off as it is fused into the material. This is a special vinyl that will fuse to the material I use not standard material that goes on shirts and jackets.
