looking for side molding and marker lights. I think you said the lights were junk but PM me what you have for molding and what you'd like to get. thanks.
IP: Logged
11:43 AM
Aug 17th, 2012
I FAR I Member
Posts: 365 From: Ontario, Canada Registered: Jan 2012
The part I need is the bracket that attaches to and secures the dogbone to the engine block on the rear side facing the trunk. It sits at a 90 degree angle inward of the dogbone/bushing and is bolted down to the rear valve cover. The dogbone is secured to this bracket.
If you have this available it would be greatly appreciated.
IP: Logged
11:06 AM
I FAR I Member
Posts: 365 From: Ontario, Canada Registered: Jan 2012
The part I need is the torque mount engine bracket that attaches to and secures the dogbone to the engine block on the rear side facing the trunk. It sits at a 90 degree angle inward of the dogbone/bushing and is bolted down to the rear valve cover. The dogbone is secured to this bracket.
If you have this available it would be greatly appreciated.
PM sent
IP: Logged
01:24 PM
I FAR I Member
Posts: 365 From: Ontario, Canada Registered: Jan 2012
Originally posted by Fiero_Guy: Do you have have the cruise control wiper stalk? I'm in need of one that works. I suspect the stalk is the fail point in my cruise control.
I probably do ... will go to the garage tomorrow ... is there an easy way to remove the stock ... I have never removed one.... THX regards Danyel
I'm looking for the little grey buttons that cover the screws around the interior door surround. I know it's not much, but 3 or 4 of them would finish off my interior!
I'm looking for the little grey buttons that cover the screws around the interior door surround. I know it's not much, but 3 or 4 of them would finish off my interior!
I'm looking for the little grey buttons that cover the screws around the interior door surround. I know it's not much, but 3 or 4 of them would finish off my interior!
Thanx if you can...
PM me your address I'll send them to ya .... free
Danyel
PM sent. And thank you once again, what a great little community we have here! Rik
IP: Logged
12:13 AM
Fiero_Guy Member
Posts: 78 From: Toronto Ontario Canada Registered: Oct 2011
I probably do ... will go to the garage tomorrow ... is there an easy way to remove the stock ... I have never removed one.... THX regards Danyel
Just pull it straight out then pull on the wire to see where the connector is should be around the fuse box area once the connector is pulled out just pull the wire through the stealing colum.
Hey Danyel, Did you check on the cruise control turn signal stalk? I also could use the cruise control servo and the other small servo vacuum release valve that next to the servo if there available too. Cheers.
PS love my DIY led sidemarkers I installed using your LED kit earlier this year makes driving with the parking light on so cool now. Lol
Hey Danyel, Did you check on the cruise control turn signal stalk? I also could use the cruise control servo and the other small servo vacuum release valve that next to the servo if there available too. Cheers.
PS love my DIY led sidemarkers I installed using your LED kit earlier this year makes driving with the parking light on so cool now. Lol
Yep got the items .. will post pics of the cruise control stock tonight
Danyel
IP: Logged
07:45 AM
BlownFiero86 Member
Posts: 295 From: Jackson,Ohio,US Registered: May 2012
