Could you post a photo showing what the end profile of the P-seal looks like? I'm not clear how these are attached. Is the felt (fuzzy material) glued to an aluminum backed molding or is the felt glued to the edge of the t-top opening? Can the felt be removed from the aluminum molding and be replaced with new felt or does the molding have to be removed? Thank you in advance for helping to clear-up my questions.
------------------ Now new owner of a Black TTop 88 Fiero GT and owner of a Silver 88 Fiero GT. Also a second time owner of an 85 Fiero GT. Bought my first fully loaded Red Fiero GT new in 1985. Fiero's are Fabulous, Fix'em and have Fun! Note, Avatar picture is Mr. Bean (not me, ha ha).
IP: Logged
09:31 AM
fieroparts.com Member
Posts: 4831 From: Maine 207-934-1969 Registered: Jun 2000
Could you post a photo showing what the end profile of the P-seal looks like? I'm not clear how these are attached. Is the felt (fuzzy material) glued to an aluminum backed molding or is the felt glued to the edge of the t-top opening? Can the felt be removed from the aluminum molding and be replaced with new felt or does the molding have to be removed? Thank you in advance for helping to clear-up my questions.
Q. I'm not clear how these are attached… A. Peal the tape off the back and 2 small 1/8 aluminum rivets on each end are what holds them on.
Q. Can the felt be removed from the aluminum molding and be replaced with new felt. A. yes
