I didn't make it. It's really good work. Light weight, got it with my car a few years ago. 2006 some time, and the glasswork is still looking good on it. It has the wire fed through it for the power trunk release. It is sold bare with no lock hardware or bumpers. I have to put that stuff back on my stock lid to sell this. I love the look of it, but I want to be just a little more low key. Car screams "something worth stealing under here".

The ectotec is just that. a stock ecotec 2.2 from a 2002 I think. Engine with intake and exhaust on it, no wiring or ecu.

The 472 was rebuilt to be mated to the 325-4L trans 3 years ago. It's got a pretty tall cam, and should be close to 600 ft/lbs. It needs some tin pieces. Oil pan. valley pan, etc. It had a edelbrock intake, and a predator carb that goes with it. If you are interested, I'll dig it out of storage and you can come see it.

The 325-4L trans is from an early 80's Eldorado. I bought the car for the trans, so I know it's a good one. It has the short axle shaft you will need.

I also have an engine hoist in good condition, and a 60 gallon 2 cyl, single stage, air compressor that need to go.

It's all absolutely make offer, nd nothing is really shippable. Throw me a PM and I'll respond to the first reasonable offer in a couple days. I'm sick of paying storage for things I'm clearly never going to use.

Make me an offer. My number is 815 383 8607

[This message has been edited by Red355SBC84 (edited 08-19-2010).]

I can't tell by looking, is the trunk lid for a GT or coupe ????? Mel

quote Originally posted by MEL H. JOHNSON: I can't tell by looking, is the trunk lid for a GT or coupe ????? Mel

Its for a Notchback, I can tell by the angle at the end of it and the round trunk seal.

[This message has been edited by mattwa (edited 08-19-2010).]

I'm sorry, I should have said.

It's for a notchie.

pm sent

pm sent on decklid

John

Have this for $750 also. It needs new tires. It's 102 inches wide, The wiring and lights are all new. I did not run the wires for the brakes out of paranoia, but never had a problem without them. It has a coat of oil based equipment enamel on it. It's a 7 pin plug, and it uses a 2-5/16 ball.





Got a pretty fair offer on the decklid, and responded.

PM sent !!!!!!

The decklid is sold.

Gonna throw out neg. prices on things

compressor $250 ( paid $390 )
Hoist $75 ( paid $135 )
Ecotec 2.2 $100 ( paid $300 )
325-4L tranny $150 ( Bought a $450 rusty Eldorado to get it. )

I know I'll never get what I have in the 472. It's still make offer.

Do you know how many miles are on the Ecotec?

I'm not sure, but it's a pretty little engine, so I couldn't see it having more than 25k or so. I'll pull it out tomorrow and get a few pictures of it for you. If you do end up wanting it, I have no trouble picking it up and setting it in the bed of a pickup. Could probably get it into a trunk with a second person.