hi im looking for the cad files for a 12'' corvette brake conversion for the 84-87's. i read that bmw guru was making them and then gave the project to another member but i cant find it in the search. also these would be for myself only, no resale or anything like that.

No guaranty on these...I have not made them myself yet. Just stored them for future reference.

https://www.fiero.nl/forum/Forum2/HTML/063914.html

thanks cowspatoot maybe ill try these, im assuming they use 88' corvette calipers? hey how far away are u from Jacksonville NC i got a marine buddy down there im trying to get him in fieros lol.

If you're still interested in BMWGuru's CAD files PM me your email address and I will email them to you.

I have a set of CAD files for my setup. Based it on the drawings found elsewhere here but found it necessary to make a couple of changes. Have the assembly in step format but could convert it to iges if that's preferred. Not going to hand over the Catia V5 files though.

Might note that I still need to verify the distance from the mounting face of the knuckle to the caliper bracket. My brakes are assembled and they work, just that instead of cutting my spacers to the correct length (which should be 34,3mm) on the lathe straight away I made do with a number of washers. Will be cutting spacers to verify the length as soon as I get the opportunity

thanks guys i got the ones i was looking for

so which ones did you get?

i will be using the ones that bmw guru made. thanks again hye_4_life

have observed a slight problem with my adapters (unexpected interference issue, working on figuring out what went wrong) so glad you opted for BMWGuru's.

PM SENT

In case you're interested in going slightly bigger with 13" Corvette brakes in the front, pm me and I am making swap brackets.

Thanks!