In the morning I am picking up a stage 2 Buick v6 it is the same as fog's. I had to buy it due to it was so cheap I am not sure if I should build it and put it in fiero

I had a Grand National,with a stock block except for the cam and ran12.20@115MPH,it also had a good exhaust system,and a big intercooler.when I sold it,with very little it would have run 11's.Shipping weight was about 3500 lbs.I haven't heard of a 4.5,only a 4.1 and a 3.8 stage 2. A Chevy would be cheaper to build.

------------------
#1112
Question my ability,question my intelligence,never question my integrity!
87drivetrain http://fieroaddiction.com/SBCTa.html

It is the stage 2 race block bored to 4 inch and it has a 3.625 stroke making it 273 CI it has 4 bolt main splayed maln caps the stage 2 block has a 4.1 casting . The crankshaft is a hank the crank piece it is set up for a dry sump I have the oil pan. the engine parts are from a NASCAR bush series race car

[This message has been edited by engine man (edited 12-21-2011).]

What about heads? cam? Manifolds?Do you need any? I may be able to help.

I have the stage 2 race head and 2 four barrel intake but I do need a cam it is setup for a solid roller lifters

If you send me your phone no.,I'll call you.Use PMs. Hugh

Pm sent have you ever dealt with Mechart rods

[This message has been edited by engine man (edited 12-22-2011).]

After checking out a few thing it appears I have a set of turbo pistons from diamond pistons that are for 6.350 rods and they are new and K1 makes rods for about $550 or I could just run the Mechart rods but I am not a big fan of the mecharts

[This message has been edited by engine man (edited 12-23-2011).]

Hugh you have a pm