Page shows coverage of a Miami Auto Show, and shows a really nice modified fiero with lambo doors. The car has been on the forum before and i believe the owner is a friend of LT188GT .
They actually kind of took a sideswipe at us by saying "No you are not seeing things that is an unscorched fiero ! "
The owner of the car is not really into clubs or forums unless it is stereo connected.
S.S. can be polished but you must have a lot of patience and time. I have played with S.S. just to see what can be done. I have a small foot square piece of stainless that I polished to a mirror finish but it is stashed some place in my shed. It was just an experiment to see what can be done.
IP: Logged
08:06 PM
kyunderdawg Member
Posts: 4373 From: Bowling Green, KY. USA Registered: Aug 2008
I used a fine rubbing compound and finished it off with A LOT of Blue Magic Metal Polish using a white polishing wheel attached to my drill motor and finished using my hands at the end.
IT WAS NOT WORTH THE EFFORT.
Like I said above, it was just a test to see what can be done. This was over two years ago.
EDIT to say that Angel MIGHT have the chrome plastic on his engine decklid. Not really sure as I have not seen Angel in quite a few months.
[This message has been edited by LT188GT (edited 04-27-2010).]
IP: Logged
09:22 PM
Apr 28th, 2010
Gwain Member
Posts: 460 From: Titusville, Florida, USA Registered: Dec 2004
You can buy polished stainless in various thicknesses from McMaster-Carr.
I've made up templates, and am in the process of cutting my first sets of trim inserts. I'm going to try some sets in polished stainless and some sets in polished aluminum (cheaper).
I should be able to post these in a week or two with pricing.
Marc
------------------ Marc in sunny Titusville, FL
84 SE son's car, loaded
85 Coup w/V6 transplant
85 GT newly on the road
86 SE/GT "The Chameleon" - big plans!
IP: Logged
09:14 AM
PFF
System Bot
Lugnut84 Member
Posts: 67 From: Fort Wayne, IN Registered: Oct 2009
Thanks Gwain for the info.. definitely post it when your done.. Santa fe springs is about 45 minutes or so from me... 24"x24" in .03 stainless "mirrored finish" is just over 62 bucks I found out... Thanks again.. They have a ton of things... well over 480,000 pieces