Anyone ever buy one of this companys engines, web site says,"The original block design is based on the GM “Iron Duke” that later evolved into the Pontiac “Super Duty” racing block." I was just curious about what it would cost.
I know probably an arm and a leg, if that's the case, than it would be too hard to drive the 4 speed. LOL sorry forgot the link.

http://www.kansasracingprod...About_the_Block.html

[This message has been edited by Grumpy0868 (edited 10-23-2009).]

Believe it is $12,500....don't know what state of assembly that is.

crazy cost for a four banger

Wow yea no doubt, thanks Jonny, I knew it would be pricey, being a racing engine,but ouch.

quote Originally posted by Grumpy0868: I was just curious about what it would cost.

They have a price list http://www.kansasracingprod....com/Price_List.html

Makes this racing engine a good deal http://usedracingparts.com/...Iron%20Duke%20Engine
------------------

World of Wheels Winners
My 3.4L S/C 87 GT
& Super Duty 4 Indy

[This message has been edited by fierosound (edited 10-24-2009).]

thanks fierosound dont know how i missed the price list.

quote Originally posted by unboundmo: crazy cost for a four banger

For a roughly 280 hp 4-cyl that is used in the ARCA Lincoln Welders Truck Series and can run full out for 100 laps.
In terms of racing engines it is cheap.

quote Originally posted by fierosound: They have a price list http://www.kansasracingprod....com/Price_List.html Makes this racing engine a good deal http://usedracingparts.com/...Iron%20Duke%20Engine

S/D Blk, Splayed caps, ARP, Roller bearings, 4” bore,dry sump, S/D crankshaft, 6” Oliver rods, T/S gapless rings, Venolia piston 13:1, Pontiac Super duty head, raised runner, Ti.valve and ret. Crane spring 2 new 215# 645# 2 Crane rollers 646” lift, 260 dur. @.050” ,Isky lifters, TD shaft mounts 1.55 Ratio, Fluid damper, custom valve and lifter cover, 2” header, MSD. 476 H.P.
Price: $ 6500 Payment Method: cash

That's still a pretty good chunk of change