Pennock's Fiero Forum
  General Fiero Chat - Archive
  looking for white gauge overlays

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


looking for white gauge overlays by gofast250
Started on: 02-14-2008 12:10 PM
Replies: 2
Last post by: Firefighter on 02-14-2008 07:37 PM
gofast250
Member
Posts: 292
From: santa maria,calif. usa
Registered: Feb 2005


Feedback score: (1)
Leave feedback

User Banned

Report this Post02-14-2008 12:10 PM Click Here to See the Profile for gofast250Send a Private Message to gofast250Direct Link to This Post
Can anyone tell me if you have had exsperience with any white gauge overlays .
I see they sell sticker or covers ,which is best .
any one place better to deal with.
Would like a complete kit dash as well as console oil,volts.
IP: Logged
PFF
System Bot
unboundmo
Member
Posts: 2242
From: California
Registered: Sep 2006


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-14-2008 12:28 PM Click Here to See the Profile for unboundmoSend a Private Message to unboundmoDirect Link to This Post
I've purchase some white gauges through http://www.speedhut.com for my wife's car. They are very clean and easy to install. They are NOT stickers. They even have both where the actual gauge glows or just the numbers in different colors. You can design your own and even add logos to them. Check it out!

Sorry to say that they don't have the panel surrounds though but this will start you off.
IP: Logged
Firefighter
Member
Posts: 1407
From: Southold, New York, USA
Registered: Nov 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-14-2008 07:37 PM Click Here to See the Profile for FirefighterSend a Private Message to FirefighterDirect Link to This Post
Unboundmo is right on track. I installed the speedhut gauges several years ago. They come with the Fiero logo and the ones I picked - blue, also change to light green with the flip of a switch. They fit perfectly and all letters and numbers are bright and clear, even the lettering around the heater controls.
Two hints, before you start, mark EXACTLY where you have to set your gas gauge needle when you put it back on and for your tach - turn the ignition to ON and replace the needle at zero (0), not where you think it is supposed to go with the ignition in the off position. Ed

------------------

[This message has been edited by Firefighter (edited 02-14-2008).]

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock