Pennock's Fiero Forum
  General Fiero Chat - Archive
  What's too much to pay for a used 3.4 pushrod?

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


What's too much to pay for a used 3.4 pushrod? by Saxman
Started on: 02-25-2006 08:57 PM
Replies: 13
Last post by: Saxman on 02-26-2006 11:40 PM
Saxman
Member
Posts: 5155
From: Melbourne, FL
Registered: May 2005


Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member

Report this Post02-25-2006 08:57 PM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
I am looking around for a good 3.4 and finding them priced from $500 - $1000 delivered. I just missed one that could have been shipped for $400 total, but someone else grabbed it. What is a decent price for a 60,000 mile 3.4 from a 94/95 Camaro?

Thanks for the help, Fiero masters!

------------------
SBC "FinIERO"
87 T-top (soon to get the FinIERO transplant)
'86 SE
www.finiero.com

IP: Logged
PFF
System Bot
ig88vsbobafett
Member
Posts: 3446
From: Cheyenne Wyoming
Registered: Oct 2001


Feedback score:    (8)
Leave feedback





Total ratings: 71
Rate this member

Report this Post02-25-2006 09:17 PM Click Here to See the Profile for ig88vsbobafettSend a Private Message to ig88vsbobafettDirect Link to This Post
www.carparts.com

they will give you list of all of them in your aera $400 to $650 for a 60k one sounds good to me aslong as its complete and good running (dont forget you will need to redrill the starter and i belive use a fiero timing chain cover/ waterpump

IP: Logged
shawnkfl
Member
Posts: 2457
From: Largo, Florida
Registered: Oct 2004


Feedback score:    (7)
Leave feedback





Total ratings: 72
Rate this member

Report this Post02-25-2006 09:23 PM Click Here to See the Profile for shawnkflSend a Private Message to shawnkflDirect Link to This Post
i just grabbed one off ebay. going to pick it up tomorrow morning for $300.00. it's the complete engine so i'll put the stuff i don't need on ebay and get a little back. i just search ebay and then narrow the search to within 200 miles from my zip code. saves shipping that way. car-parts.com will search near your zip too and they usually have really good prices.
IP: Logged
Saxman
Member
Posts: 5155
From: Melbourne, FL
Registered: May 2005


Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member

Report this Post02-26-2006 12:22 AM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
I just tried both and they had nothing on either. parts.com didn't show any anywhere, so maybe I was looking in the wrong category. I am hoping to spend $400 or elow.

Thanks for the help!!!

IP: Logged
Fastback 86
Member
Posts: 7849
From: Los Angeles, CA
Registered: Sep 2003


Feedback score: (1)
Leave feedback





Total ratings: 231
Rate this member

Report this Post02-26-2006 03:33 AM Click Here to See the Profile for Fastback 86Send a Private Message to Fastback 86Direct Link to This Post
Mine cost $864 before the $50 they gave me for what was left of the 2.8. Had to drive an hour and a half each way, too.
IP: Logged
cooguyfish
Member
Posts: 2658
From: Hamilton, OH, USA
Registered: Mar 2002


Feedback score: (2)
Leave feedback





Total ratings: 72
Rate this member

Report this Post02-26-2006 08:18 AM Click Here to See the Profile for cooguyfishSend a Private Message to cooguyfishDirect Link to This Post
 
quote
Originally posted by Saxman:

I just tried both and they had nothing on either. parts.com didn't show any anywhere, so maybe I was looking in the wrong category. I am hoping to spend $400 or elow.

Thanks for the help!!!

parts.com or did you go to car-parts.com?


car-parts.com is highly recommended by myself. I've searched on it quite a bit for engines and such.

------------------
AIM= Fish100770
96 Saturn SL2 Turbo (evil SL2)

My cardomain site: cardomain.com/memberpage/702872

IP: Logged
FieroVin
Member
Posts: 951
From: Raleigh, NC, USA
Registered: May 2005


Feedback score: (1)
Leave feedback

Rate this member

Report this Post02-26-2006 09:32 AM Click Here to See the Profile for FieroVinClick Here to visit FieroVin's HomePageSend a Private Message to FieroVinDirect Link to This Post
 
quote
Originally posted by shawnkfl:

i just grabbed one off ebay. going to pick it up tomorrow morning for $300.00. it's the complete engine so i'll put the stuff i don't need on ebay and get a little back. i just search ebay and then narrow the search to within 200 miles from my zip code. saves shipping that way. car-parts.com will search near your zip too and they usually have really good prices.

Man... I've been watching e-bay, and whenever I see anything good, it's 1200 miles away. I know, must be patient, and keep watching.

Anyway, around here, they seem to between $450 $1000 depending on mileage, I'd say for the mileage listed above, it would be in the $800 range, from what I've seen. I'm holding out for that bargain though.

IP: Logged
Fastback 86
Member
Posts: 7849
From: Los Angeles, CA
Registered: Sep 2003


Feedback score: (1)
Leave feedback





Total ratings: 231
Rate this member

Report this Post02-26-2006 03:17 PM Click Here to See the Profile for Fastback 86Send a Private Message to Fastback 86Direct Link to This Post
 
quote
Originally posted by cooguyfish:


parts.com or did you go to car-parts.com?


car-parts.com is highly recommended by myself. I've searched on it quite a bit for engines and such.

Second. Thats how I found my 39k mile motor an hour and a half away.

IP: Logged
aerosmithr0cker
Member
Posts: 1199
From: Charlotte, NC, USA
Registered: Aug 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-26-2006 03:50 PM Click Here to See the Profile for aerosmithr0ckerSend a Private Message to aerosmithr0ckerDirect Link to This Post
I know a guy selling a 12,000 mile 3.4 and 100,000 mile 3.4 with starter holes already drilled for fiero application. I got his email address if you want he is located in concord, NC.
IP: Logged
Custom2M4
Member
Posts: 4414
From: Winnipeg, Manitoba Canada
Registered: Sep 2004


Feedback score: (3)
Leave feedback





Total ratings: 114
Rate this member

Report this Post02-26-2006 04:33 PM Click Here to See the Profile for Custom2M4Send a Private Message to Custom2M4Direct Link to This Post
I got mine shipped for 400 dollars CDN.... I thought that was a pretty good deal at the time.. It had to have had quite a few miles on it though, and had been sitting for a while. I changed my mind about leaving the bottom end, simply because it obviously wasn't up to par..
IP: Logged
shawnkfl
Member
Posts: 2457
From: Largo, Florida
Registered: Oct 2004


Feedback score:    (7)
Leave feedback





Total ratings: 72
Rate this member

Report this Post02-26-2006 09:11 PM Click Here to See the Profile for shawnkflSend a Private Message to shawnkflDirect Link to This Post
here's the one i picked up today

keep watching ebay and car-parts.com. they turn up eventually!

IP: Logged
PFF
System Bot
sonic50
Member
Posts: 3873
From: All over the USA
Registered: Aug 2004


Feedback score: N/A
Leave feedback





Total ratings: 92
Rate this member

Report this Post02-26-2006 10:29 PM Click Here to See the Profile for sonic50Send a Private Message to sonic50Direct Link to This Post
I got one from a guy in SC for $250 dollers. It has about 70,000 miles on in.

------------------

www.iamanascarfan.com

IP: Logged
88White3.4GT
Member
Posts: 1604
From: Hayward, CA
Registered: Dec 2003


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-26-2006 10:38 PM Click Here to See the Profile for 88White3.4GTSend a Private Message to 88White3.4GTDirect Link to This Post
my crate motor was $2 grand.
IP: Logged
Saxman
Member
Posts: 5155
From: Melbourne, FL
Registered: May 2005


Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member

Report this Post02-26-2006 11:40 PM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
 
quote
Originally posted by 88White3.4GT:

my crate motor was $2 grand.

What kind of work was done on that one?

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock