Pennock's Fiero Forum
  General Fiero Chat - Archive
  Who reproduces mecham quarter panel scoops? (Page 2)

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version

This topic is 2 pages long:  1   2 
Previous Page | Next Page
Who reproduces mecham quarter panel scoops? by Iron_Mark_2003
Started on: 07-08-2004 03:37 AM
Replies: 40
Last post by: AusFiero on 01-01-2005 06:52 PM
AusFiero
Member
Posts: 11513
From: Dapto NSW Australia
Registered: Feb 2001

Feedback score: (2)
Leave feedback





Total ratings: 327
Rate this member
Report this Post01-01-2005 06:52 PM Click Here to See the Profile for AusFieroClick Here to visit AusFiero's HomePageSend a Private Message to AusFieroDirect Link to This Post
I contacted the original makers of the Mecham scoops to try get the original moulds/dies but they had sold them to a Fiero club many years ago. They have disappeared basically. With the original metal dies I could have had them reproduced for a much better price than fibreglass. A real shame the original dies are MIA. To make new dies is too expensive to justify.

------------------

IP: Logged
Previous Page | Next Page

This topic is 2 pages long:  1   2 

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock