Tried in vain and just couldn't find what I was looking for and we all know your the man when it comes to searches. Anyways I need to repiar the screw holes from my trim pieces (I recall a thread on doing it with expoxy). also if you recall any threads on fixing the seat handle (black part with the tabs that break I need to fix those also. TIA!
[This message has been edited by linenoise (edited 04-14-2004).]
IP: Logged
09:24 PM
PFF
System Bot
Racingman24 Member
Posts: 2304 From: Land of 10,000 Idiots Registered: Apr 2003
Did you find out where the fluid was coming from???
Ummm... the bottom of the car
I actually cleared the drainage tubes up front (see my post over in Tech). As for the fluid (what appeared to be from the tranny) - I jacked the car up, but due to my rib injury I couldn't maneuver under the car very well... so I warmed up the tranny and checked the fluid (which was only slightly low) - but I think I'll have to take it to Shawn's (maybe on Sat) to get a better look and to locate the source. <shrug>
IP: Logged
11:11 PM
Racingman24 Member
Posts: 2304 From: Land of 10,000 Idiots Registered: Apr 2003
I actually cleared the drainage tubes up front (see my post over in Tech). As for the fluid (what appeared to be from the tranny) - I jacked the car up, but due to my rib injury I couldn't maneuver under the car very well... so I warmed up the tranny and checked the fluid (which was only slightly low) - but I think I'll have to take it to Shawn's (maybe on Sat) to get a better look and to locate the source. <shrug>
You could've just said "no"
IP: Logged
11:14 PM
Firefox Member
Posts: 4307 From: New Berlin, Wisconsin Registered: Feb 2003
After the workload they (unexpectedly) dumped on me this week at the office, it looks like I won't make it down this weekend... I'll be down in that area the weekend after though!
