I was thinking it would be easier to pull the WHOLE column and steering wheel for example from a Firebird to get a good column and a new steering wheel at the same time.

Well... Anyone know??

------------------
SmoothGT!!
PostWhore of PFF!!

You could try using the Firebird column but from my observation, (I have one in my parts room) it appears to be about 6 to 8 inches too long. You could shorten it, but I don't have enough confidence in my welding skills to weld on something as critical as the steering column.

You might have more luck on the column from a smaller car like the Sunfire or Grand Am.

quote Originally posted by jscott1: You might have more luck on the column from a smaller car like the Sunfire or Grand Am.

Thanks Johnathan...

Will those bolt up..?? What about all the plug's..??
I am going to the Junkyard in the AM. so i need some new stuff to look for.. I LOVE THAT PLACE!!

steve

All GM/Saginaw columns that I have seen use the same basic mounting scheme, but I doubt any of them are bolt up replacements. But I haven't done a lot of research either.

There was a guy that used a column off an Alero and only had to move the brackets around a little. I don't know what other ones are close.

quote Originally posted by Smoooooth GT: I am going to the Junkyard in the AM. so i need some new stuff to look for.. I LOVE THAT PLACE!! steve

What's ya getting me?????

------------------

98 3800SC GTP motor, 5sp.
custom hood,trunk,side scoops,IRM front spoiler, dk.Shadow Grey