Pennock's Fiero Forum
  General Fiero Chat - Archive
  Installed the rear poly bushings and KYBs + Thanks MN gang

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Installed the rear poly bushings and KYBs + Thanks MN gang by RACE
Started on: 06-24-2003 01:04 AM
Replies: 0
Last post by: RACE on 06-24-2003 01:04 AM
RACE
Member
Posts: 4845
From: Des Moines IA
Registered: Dec 2002


Feedback score:    (45)
Leave feedback





Total ratings: 157
Rate this member

Report this Post06-24-2003 01:04 AM Click Here to See the Profile for RACEClick Here to visit RACE's HomePageSend a Private Message to RACEDirect Link to This Post
Today. I finally had time to install the poly bushings on the driver's side of the car. The back is done and ready to be aligned. I was a little surprised when the center part of the bushing shot out of the burning rubber. I had no idea that it would have that much force. The nasty soot burning rubber smell, and dripping, flaming, rubber was fun too. It came apart and went together very nicely.

I may be able to do the fronts tomorrow and get it aligned next week. It depends on what pops up.


BTW, Thanks to the Minnesota gang for lettting me look at your cars over the weekend. Always a pleasure. I got some really good ideas. All of the cars and owners were very nice. Hopefully I can bring my car to the next one.

------------------

American Exotic

IP: Logged
PFF
System Bot



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock