You can make a cut in the lid on the side facing the window and remove the steel plate. The steel piece is a bent piece of steel at a 90 degree bend. It is held in place with a few rivets that can be drilled out. Drill out the rivets and cut the hole and it slides out. Drill out the old holes. Weld nuts on to it and reinstall it, Rivet it back in and patch the hole. The hole is basically not seen.
------------------
Rodney Dickman
Fiero Parts And Acc's Web Page:
All new web page!:www.rodneydickman.com
Rodney Dickman's Fiero accessories
7604 Treeview Drive
Caledonia, WI 53108
Phone/Fax (262) 835-9575