Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  3.4 PR clutch choice.

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
3.4 PR clutch choice. by Celthora87GT
Started on: 02-23-2013 01:11 PM
Replies: 3
Last post by: iphasterlo on 02-25-2013 01:23 PM
Celthora87GT
Member
Posts: 1485
From: New Berlin, WI
Registered: Dec 2010

Feedback score: (5)
Leave feedback

Rate this member
Report this Post02-23-2013 01:11 PM Click Here to See the Profile for Celthora87GTSend a Private Message to Celthora87GTDirect Link to This Post
I am FINALLY looking for clutches. (its been a rough couple months) and I found an F1 stage 3(any good?) and an eCLUTCHMASTER stage 2 for about the same price. Both are 6sprung. Which is a better brand and which would last longer?
eCLUTCHMASTER
http://www.ebay.com/itm/85-...em1e73c91b7b&vxp=mtr
F1
http://www.ebay.com/ itm/F1-...em5d3a6d095c&vxp=mtr
Both come with throwout bearing and both come with the clutch centering tool.

[This message has been edited by Celthora87GT (edited 02-23-2013).]

IP: Logged
PFF
System Bot
Kento
Member
Posts: 4218
From: Beautifull Winston Salem NC
Registered: Jun 2003

Feedback score: (2)
Leave feedback





Total ratings: 131
Rate this member
Report this Post02-23-2013 06:48 PM Click Here to See the Profile for KentoSend a Private Message to KentoDirect Link to This Post
FWIW, I am going to try the 2nd one with my 4.9 swap.

------------------

****************************************

88 Formula CJB Arrived Finally. #689 of 1252
Time to start Working TONY!
There are Two kinds of Fiero's : Notchies and Donors!

IP: Logged
hnthomps
Member
Posts: 5762
From: Columbia, SC
Registered: Jul 2003

Feedback score:    (18)
Leave feedback





Total ratings: 51
Rate this member
Report this Post02-25-2013 11:22 AM Click Here to See the Profile for hnthompsSend a Private Message to hnthompsDirect Link to This Post
I have been running a SPEC Stage 2 on a 3.4 turbo setup for about six years and am very satisfied.

Nelson
IP: Logged
iphasterlo
Member
Posts: 17
From: Omaha Ne USA
Registered: Jan 2012

Feedback score: N/A
Leave feedback

Rate this member
Report this Post02-25-2013 01:23 PM Click Here to See the Profile for iphasterloSend a Private Message to iphasterloDirect Link to This Post
I have the stage 3 6 puck from spec. as long as you clean and resurface the flywheel and follow the proper break in process it should be good. I love the clutch, it holds my 3.4 without an issue and doesnt rattle or slip either
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock