Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  2.8L V6 engine block drain plug? Same as Drain Plugs on Coolant Tubes?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
2.8L V6 engine block drain plug? Same as Drain Plugs on Coolant Tubes? by hdryder
Started on: 03-18-2012 11:03 AM
Replies: 1
Last post by: Raydar on 03-18-2012 11:24 AM
hdryder
Member
Posts: 674
From: Virginia Beach, VA, USA
Registered: Apr 2011

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-18-2012 11:03 AM Click Here to See the Profile for hdryderSend a Private Message to hdryderDirect Link to This Post
Where is the 2.8L Engine Block Drain Plug located, that is mention in the Haynes Repair Manual, page 2B-6, section 9, step 2?

I see the drain plugs on the coolant tubes. Are those what they mean?

Thanks for the help.
IP: Logged
PFF
System Bot
Raydar
Member
Posts: 41332
From: Carrollton GA. Out in the... country.
Registered: Oct 1999

Feedback score:    (13)
Leave feedback





Total ratings: 460
Rate this member
Report this Post03-18-2012 11:24 AM Click Here to See the Profile for RaydarSend a Private Message to RaydarDirect Link to This Post
The engine block has drain plugs too.
They are a couple of inches above the pan rail, on each side. Possibly towards the flywheel end, but I don't remember for sure. Been a while.
Seems like it's a hex head. 12-13mm wrench. They might be rusted in place. Be careful.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock