every thing is going wrog with this thing it is an 84 se all stock first it wont start in less you jump the pump on with 12vs then now a new thing to add to my list it wont shift every thing works up to the slave that i can see i just cant see the rest to tell you if it working right but the slave is at its point where it cant move any more and it seems the arms not moveing engh to disengage the clutch new every thing in side the tramisstion and i cant fuger this out for the life of me.
IP: Logged
12:28 PM
PFF
System Bot
Racing_Master Member
Posts: 1460 From: Hooksett, NH, USA Registered: Nov 2007
Did you check if your Fuel Pump Relay is getting the signal to trigger? You jump the fuel pump at the relay? Try just swapping relays with a known good relay?
Also for the shifting, you mean the clutch right? if it is not moving enough, you most likely have air in the system, and have to bleed it out. People have a lot of problems bleeding clutches, it can be a big pain if you do not have a pressure bleeder.
no the slave has mmax out gone as far as it could and the pedel is rock hard and for the relay thing i chage them once and it start right up next day i when out to try it again and nothing and the relay is good im at a dead road hear
Funny thing, my 86 Sprot had been sitting since 06' . I finally got it running last night, it's on Jack Stands so I decide to put it in gear. It wouldn't go. I checked the fluid. It was BLACK but it's all there. I got in and started pumping the clutch and it finally pumped up enough to shift perfectly. I don't know why it did it, but pumping helped in my case. Now before I start driving i will change the fluid and bleed it off again. But in a pinch, air in the lines will pump up temporarily
------------------ 86 Fiero 2M4 Silver, bought for electric conversion. Currently just fixing all the old stuff
Funny thing, my 86 Sprot had been sitting since 06' . I finally got it running last night, it's on Jack Stands so I decide to put it in gear. It wouldn't go. I checked the fluid. It was BLACK but it's all there. I got in and started pumping the clutch and it finally pumped up enough to shift perfectly. I don't know why it did it, but pumping helped in my case. Now before I start driving i will change the fluid and bleed it off again. But in a pinch, air in the lines will pump up temporarily
------------------ 86 Fiero 2M4 Silver, bought for electric conversion. Currently just fixing all the old stuff
When you say it won't shift....is the shifter moving at all? up-down? left-right? If the cables are working properly, then the next thing would be internal, throw-out bearing maybe.
the thing is all that stuff is new and it all hafe way works just not full disengaging and the system has no air in it and the slave is taping out wich is makeing the pedel rock hard
IP: Logged
01:33 PM
PFF
System Bot
Gall757 Member
Posts: 10938 From: Holland, MI Registered: Jun 2010
