Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Broken connecting Rod L26 3800 (Page 2)

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version

This topic is 2 pages long:  1   2 
Previous Page | Next Page
Broken connecting Rod L26 3800 by Justinbart
Started on: 03-31-2011 07:46 PM
Replies: 41
Last post by: engine man on 04-15-2011 07:45 PM
1fatcat
Member
Posts: 1519
From: Zimmerman, Mn
Registered: Dec 2010

Feedback score: N/A
Leave feedback

Rate this member
Report this Post04-15-2011 08:31 AM Click Here to See the Profile for 1fatcatSend a Private Message to 1fatcatDirect Link to This Post
These engines use full floating wrist pins...just saying.
IP: Logged
engine man
Member
Posts: 5298
From: Lebanon NH
Registered: Mar 2006

Feedback score: (5)
Leave feedback

Rate this member
Report this Post04-15-2011 07:45 PM Click Here to See the Profile for engine manSend a Private Message to engine manDirect Link to This Post
ya they use full floating pins that are set tight running with less than a 1/2 a thousands clearance and when building a race engine you set the clearance at 3/4 to 1 thousands of a inch
IP: Logged
Previous Page | Next Page

This topic is 2 pages long:  1   2 

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock