Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  What tools are required to replace the kickdown/detent cable?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
What tools are required to replace the kickdown/detent cable? by greenfiero1986
Started on: 03-27-2011 11:28 AM
Replies: 2
Last post by: greenfiero1986 on 03-27-2011 05:37 PM
greenfiero1986
Member
Posts: 161
From: Newark, OH, USA
Registered: Feb 2011

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2011 11:28 AM Click Here to See the Profile for greenfiero1986Send a Private Message to greenfiero1986Direct Link to This Post
Wanting to change it today and I was just curious to if I needed any special tools.
IP: Logged
PFF
System Bot
fotofrank
Member
Posts: 1034
From: Elgin IL
Registered: Feb 99

Feedback score: (2)
Leave feedback

Rate this member
Report this Post03-27-2011 02:55 PM Click Here to See the Profile for fotofrankClick Here to visit fotofrank's HomePageSend a Private Message to fotofrankDirect Link to This Post

No special tools required. You just need patients if replacing this on a Duke.

Frank
IP: Logged
greenfiero1986
Member
Posts: 161
From: Newark, OH, USA
Registered: Feb 2011

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2011 05:37 PM Click Here to See the Profile for greenfiero1986Send a Private Message to greenfiero1986Direct Link to This Post
Oh this is a 2.8 V6
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock