Hello Everyone,

I am currently trying to install a passenger side window in my Fiero. It does have power windows, don't know if that affects anything. I did a search and could not find any threads. How do I get the new window in the door? Thanks for any help!

Semper Fi,
D. Shafer

------------------
Project "Devil Dog" - Special Thanks To Spoon, Shawnhalolush, MstangsBware

01 GTP 3800SC Series 2 "Rebuilding"

You have to drill of the rivets holding the rollers on and place them wit 1/4" bolts and nylock nuts, but dont overtighten !! The glass will shatter, dont ask ! You will need to remove the inner door panel dew wipe ans rubber seals at the front and rear of the door. Also may need to loosen the guide tracks and remove the two felt guides under the inner dew wipe.

When doing your search change the right hand box to "entire thread" and you will get what you are looking for

Here's a good thread to read

https://www.fiero.nl/forum/Forum2/HTML/100150.html

Very cool, +'s for both of you. I hope I don't shatter my window as well, good advice there! Take care 8)

Side windows are made of tempered glass. Stress them enough and they instantly will break up into little gravel sized pieces.

Yours isn't 1/2 inch so it will break easier.

[This message has been edited by phonedawgz (edited 12-21-2010).]