I'm going to install a sub amp under my passenger seat today and was wondering where was the best/closest place to run the ground. I'm thinking one of the four seat bolts. This would work right?

------------------
~Stan
http://www.StanHinesleyPickups.com
-----------------------------------------------------------------------------------
"No, it's not an MR2!!!"

I used a seat bolt for my system in my blazer years ago. 2 12's, 1000 watt amp. Nvr had a issue with it.

Better use a bolt and find solid metal to put in.

Seat mount can cause problems. Seat mount going thru carpet and insulation and in Fiero, they get rusty.

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)

The Ogre's Fiero Cave (It's also at the top of every forum page...)

Passenger seat.... Battery is just on the other side of the firewall. /shrug.

Find a good clean metal spot, grind away the paint with a dremel/sandpaper, and bolt your ground lug to that point.

To protect from corrosion, you can slather the area with grease.