Will this work in a Fiero? The Engine is a Modified Ford 3.0 Duratec 425hp Twin Turbo(2002+ Ford Escape) and the Transmission is a Manual 6 speed Getrag( out of Ford Mondeo/ kuga suv).

[This message has been edited by Waffen-WS6 (edited 05-15-2009).]

With enough money just about anything's possible. It's a transverse setup, so you have that going for you. Personally I'd skip the fiero and just drive the noble

For your first post, you came up with a Doozie!

quote Originally posted by Tony Kania: For your first post, you came up with a Doozie!

I don't mess around. . Currently I'm looking to find out if any other Ford transmissions in the U.S. fit the 3.0 Duratec v6. Only things I see are MTX-75 and getrag 285(Focus SVT) and I have no idea if they bolt up to a v6.

Edit: Manual Transmissions
------------------
97 WS6 M6

[This message has been edited by Waffen-WS6 (edited 05-15-2009).]

Just build a Noble. It's available as a kit, right?

quote Originally posted by Will: Just build a Noble. It's available as a kit, right?

I don't have 70,000 and if I did I wouldn't spend it on a car. I can get a 3.5 Duratec all aluminum 265 HP for about 1200 from a junkyard. It already has a forged crank, I think the only weak link is the pm rods. Apparently the MTX75 transaxle will bolt up to the v6 duratecs, but only the svt contour version from what I've read.

quote Originally posted by Waffen-WS6: Will this work in a Fiero? The Engine is a Modified Ford 3.0 Duratec 425hp Twin Turbo(2002+ Ford Escape) and the Transmission is a Manual 6 speed Getrag( out of Ford Mondeo/ kuga suv).

no comments

[This message has been edited by FierociousGT (edited 05-15-2009).]