Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Removing Inner Wheel Bearing

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Removing Inner Wheel Bearing by fiero87gt
Started on: 04-17-2009 04:49 PM
Replies: 1
Last post by: Mike Gonzalez on 04-17-2009 04:56 PM
fiero87gt
Junior Member
Posts: 1
From: Bowmanville, Ontartio Canada
Registered: Apr 2009

Feedback score: N/A
Leave feedback

Rate this member
Report this Post04-17-2009 04:49 PM Click Here to See the Profile for fiero87gtClick Here to visit fiero87gt's HomePageSend a Private Message to fiero87gtDirect Link to This Post
Quick question for you all. The inner wheel bearing is stuck in the rotor and I don't just want to bang away on it to get it out. What is the easiest way to get it out without damaging the bearing and seal. Thanks in advance for your help.
IP: Logged
PFF
System Bot
Mike Gonzalez
Member
Posts: 5093
From: Colorado Springs, CO. USA
Registered: Jul 2001

Feedback score: (1)
Leave feedback





Total ratings: 130
Rate this member
Report this Post04-17-2009 04:56 PM Click Here to See the Profile for Mike GonzalezSend a Private Message to Mike GonzalezDirect Link to This Post
Put it back on the spindle, put the spindle nut on so its flush with the end of the spindle, slide the rotor off using the nut as a ram on the inside of the bearing, rotate 30 degrees repeat untill it comes out.

Welcome to the Forum !

[This message has been edited by Mike Gonzalez (edited 04-17-2009).]

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock