Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Which release bearing to buy?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Which release bearing to buy? by MooCow
Started on: 02-13-2009 01:41 PM
Replies: 2
Last post by: MooCow on 02-13-2009 06:48 PM
MooCow
Member
Posts: 2263
From: Charlotte, NC
Registered: Sep 1999

Feedback score:    (22)
Leave feedback

Rate this member
Report this Post02-13-2009 01:41 PM Click Here to See the Profile for MooCowSend a Private Message to MooCowDirect Link to This Post
I have an 86GT with the Muncie 4speed. The engine I just bought has a Centerforce Clutch installed with pressure plate. I still have my original release bearing, but figure I should swap that out since it has 157K miles on it. I believe I just buy the release bearing for the transmission, not for the clutch. Can I just buy a stock one and be fine? Also where is the best place to buy one at?

Thanks,

Ken~
IP: Logged
PFF
System Bot
Synthesis
Member
Posts: 12207
From: Jordan, MN
Registered: Feb 2002

Feedback score:    (19)
Leave feedback





Total ratings: 294
Rate this member
Report this Post02-13-2009 02:10 PM Click Here to See the Profile for SynthesisSend a Private Message to SynthesisDirect Link to This Post
Buy the release bearing for the transmission. The stock one is fine.

IP: Logged
MooCow
Member
Posts: 2263
From: Charlotte, NC
Registered: Sep 1999

Feedback score:    (22)
Leave feedback

Rate this member
Report this Post02-13-2009 06:48 PM Click Here to See the Profile for MooCowSend a Private Message to MooCowDirect Link to This Post
Cool, thanks for the info

Ken~
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock