Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  ground wire issue

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
ground wire issue by dsalmen
Started on: 11-06-2008 07:21 AM
Replies: 2
Last post by: dsalmen on 11-06-2008 07:59 AM
dsalmen
Member
Posts: 87
From: VA
Registered: Oct 2005

Feedback score: N/A
Leave feedback

Rate this member
Report this Post11-06-2008 07:21 AM Click Here to See the Profile for dsalmenSend a Private Message to dsalmenDirect Link to This Post
I have an 87 notchy which was originally a 4cyl - now a 3.4 v6 after swap. I also have a cold air intake and have removed the coolant lines to the throttle body. There is a ground wire that goes from the engine hatch hinge (driver side) that I believe used to go to clip on the coolant lines to the throttle body which have been removed. Any thoughts on where to clip it now - or just remove it?

Thx,
dave s

------------------
87 notchback w/ stroked 3.4

IP: Logged
PFF
System Bot
Robs Fieros
Member
Posts: 723
From: Athens, Tennessee
Registered: Oct 2004

Feedback score: (4)
Leave feedback

Rate this member
Report this Post11-06-2008 07:46 AM Click Here to See the Profile for Robs FierosSend a Private Message to Robs FierosDirect Link to This Post
Move it to the passengers side hood hinge and bolt the other end to the oil sending unit bracket. That's where they normally go on the V6 cars.
IP: Logged
dsalmen
Member
Posts: 87
From: VA
Registered: Oct 2005

Feedback score: N/A
Leave feedback

Rate this member
Report this Post11-06-2008 07:59 AM Click Here to See the Profile for dsalmenSend a Private Message to dsalmenDirect Link to This Post
Sounds good - appreciate the info.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock