if i put a 95 camaro 3.4 in my 87 fiero can i use my fieros ignition system(plugs, coil, plugs, distributor ?
cause my fiero has all new ones and the 3.4 is used im getting so rather use new ones than used.
and also can i use my exhaust manifolds and y pipe and everything else for exhaust?
thanks

Yes - and yes

And timing cover and water pump.

Watch the flywheel. You want an 88 flywheel since a 3.4 is internal balanced.
Of course you have to relocate the starter and plug the cam sensor hole or just leave the sensor.

And if the engine has sat a while I'd also pop the freeze plugs while your at it and clean the coolant passages out.
You can see just some of the jumk I got out of mine on my post.. I used a coat hanger and scraped around the cyl while I flushed with water. Just make your used engine run that much cooler. Plugs are cheap also.
https://www.fiero.nl/forum/F...2/HTML/072303-3.html

[This message has been edited by Dodgerunner (edited 06-24-2008).]