Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Alum spec 3800 flywheel fitment issues

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Alum spec 3800 flywheel fitment issues by darkhorizon
Started on: 06-07-2008 04:53 PM
Replies: 1
Last post by: Jncomutt on 06-07-2008 10:42 PM
darkhorizon
Member
Posts: 12279
From: Flint Michigan
Registered: Jan 2006

Feedback score: (1)
Leave feedback





Total ratings: 451
Rate this member
Report this Post06-07-2008 04:53 PM Click Here to See the Profile for darkhorizonSend a Private Message to darkhorizonDirect Link to This Post
Installed a spec alum flywheel onto my latest project today, and it was .017 smaller than the "carrier" on the crankshaft. Took about 30 mins of sanding with a dremel to get it so it would fit. It sure was shiny when I was done

I am at least glad that it wasnt too big.. but it seems like they could have tried a bit harder than they did..... Bolts lined up flawlessly after it fit onto the crank.
IP: Logged
PFF
System Bot
Jncomutt
Member
Posts: 8916
From: Charlotte, NC
Registered: Apr 2001

Feedback score: (3)
Leave feedback





Total ratings: 221
Rate this member
Report this Post06-07-2008 10:42 PM Click Here to See the Profile for JncomuttSend a Private Message to JncomuttDirect Link to This Post
Did you contact SPEC? Letting us knows gives us the heads up, letting them know helps get the problem corrected.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock