Coolant lines 88 need help

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Coolant lines 88 need help by pcwentworth

Started on	: 04-20-2008 11:11 PM
Replies	: 4
Last post by	: SuperchargedV6 on 04-21-2008 02:21 PM

pcwentworth
Member

Posts: 411
From: New Concord, Ohio, United States
Registered: May 2005

Feedback score: (1)
Leave feedback

Rate this member

Report this Post04-20-2008 11:11 PM

Working on getting an 88 v6 in my Fiero (complete swap, out with the 4 in with the 6) I could be loosing it but where is the inlet on the 88v6 engine? There should be two for coolant going in should there not? But I only see one. Does anyone have pictures? Is the 88 different from other years?

IP: Logged

PFF

System Bot

Hudini
Member

Posts: 9029
From: Tennessee
Registered: Feb 2006

Feedback score: N/A
Leave feedback

Total ratings: 165
Rate this member

Report this Post04-20-2008 11:32 PM

The out would be on the thermostat housing, the in on the water pump. The out connects to the crossover pipe that goes in front of the engine, the in connects to the pax side under car coolant pipe.

[This message has been edited by Hudini (edited 04-20-2008).]

IP: Logged

jscott1
Member

Posts: 21676
From: Houston, TX , USA
Registered: Dec 2001

Feedback score:

(15)
Leave feedback

Total ratings: 415
Rate this member

Report this Post04-21-2008 01:35 PM

quote

Originally posted by pcwentworth:

There should be two for coolant going in should there not? But I only see one.

If you mean two going in because of the heat hose lines? no they T- together before the water pump at the coolant tube and there is only one inlet at the water pump.

IP: Logged