Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  C500 connector

T H I S   I S   A N   A R C H I V E D   T O P I C

Email This Page to Someone! | Printable Version

C500 connector by MoeBawlz
Started on: 03-31-2008 09:00 PM
Replies: 1
Last post by: FIEROFLYER on 04-01-2008 07:42 AM
Posts: 107
From: Palatine
Registered: Mar 2008

Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-31-2008 09:00 PM Click Here to See the Profile for MoeBawlzSend a Private Message to MoeBawlzDirect Link to This Post
I am going to be relocating the C500 connector on my car due to it starting to have melting issues and it being an 84 and I have read that you need to move them so you dont melt them entirely when you install a V6 which is the next step.

My question is how do you remove them? I dont want to break them and I dont see any real simple way of getting them apart, is there a trick?
IP: Logged
System Bot
Posts: 3974
Registered: Oct 2002

Feedback score:    (13)
Leave feedback

Total ratings: 180
Rate this member

Report this Post04-01-2008 07:42 AM Click Here to See the Profile for FIEROFLYERSend a Private Message to FIEROFLYERDirect Link to This Post
Un bolt the connector from the firewall then physically move it toward the driver's side and either cut off the old mount plate and reweld it in place or mount it to the plate that holds the relays and move the relays further over. All you need tol do is move it far enough to the one side to clear the exhaust manifolds. There is a few photos in the link nelow my sig that show it moved. Dan


Signature compliments of F-I-E-R-O
2003 3800SC series II powered

IP: Logged

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock