Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Knock off wheels?

T H I S   I S   A N   A R C H I V E D   T O P I C

Email This Page to Someone! | Printable Version

Knock off wheels? by The_Stickman2
Started on: 11-24-2007 11:29 PM
Replies: 0
Last post by: The_Stickman2 on 11-24-2007 11:29 PM
Posts: 1030
From: Lehigh Valley Pa.
Registered: Sep 2007

Feedback score: (1)
Leave feedback

Rate this member

Report this Post11-24-2007 11:29 PM Click Here to See the Profile for The_Stickman2Click Here to visit The_Stickman2's HomePageClick Here to Email The_Stickman2Send a Private Message to The_Stickman2Direct Link to This Post
Has anyone done knock off wheels on a Fiero? I really would like to do this on my IMSA for that race car look. But what I have found so far is this. The kits come two ways. Either with locating studs for mostly rear drive performance cars. Or with a splinned hub and wheel for the lowrider crowd. There are some fwd kits out there but those kits fit those rims. And the lowrider type rims are NOT what I am after. So what to do? I want a wheel with one center nut just like the Dingman bros. GTO Fiero.
IP: Logged
System Bot

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock