Howdy there. Joseph Upton authored a good thread on the G6's 6 speed manual being mated to a 60 degree V6, but has anyone yet mated it to a 3800? Series II L67 in this case. I know that they will bolt up at the bell housings, but don't know how the clutch, pressure plate, flywheel, slave cylinder, and axles would work out. Could one of you point me to another thread if this has already been dicussed? Thanks.

I have a flywheel made and have the clutch set made for this app. I haven't started on the axles yet but have some ideas...

http://i198.photobucket.com...6flywheelcustom2.jpg

http://i198.photobucket.com...6flywheelcustom3.jpg

http://i198.photobucket.com...ech/stage4clutch.jpg

I'll let you know how thing are coming within a month or so.

Joe

------------------

Street Legal Tuning.

Specializing in Fiero performance:
3800 swaps, custom Aluminum flywheels, Brakes, Engine's, Aftermarket Bolt on performance parts, used Fiero parts,
www.iactech.com e-mail: joetrentadue@hotmail.com

Race Tech: please check your email/PM