Rear Axle nut size on '88 Fiero? - Pennock's Fiero Forum

Click here to visit the donation page | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

Rear Axle nut size on '88 Fiero?

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Rear Axle nut size on '88 Fiero? by jsantini

Started on	: 06-24-2007 01:13 PM
Replies	: 2
Last post by	: jsantini on 06-24-2007 09:36 PM

jsantini
Member

Posts: 44
From: columbia, NJ, USA
Registered: May 2007

Feedback score: N/A
Leave feedback

Rate this member

Report this Post06-24-2007 01:13 PM

Send a Private Message to jsantini

Direct Link to This Post

Anyone know offhand what the rear axle nut size is on an '88? My Haynes manual doesn't say. I know it's a little smaller than a 1 1/4 inch, but it needs a deep socket, not sure if it's metric or English. Thanks-

IP: Logged

PFF

System Bot

Rodrv6
Member

Posts: 1910
From: Ball Ground, Ga.
Registered: Nov 1999

Feedback score: (2)
Leave feedback

Total ratings: 76
Rate this member

Report this Post06-24-2007 01:22 PM

Send a Private Message to Rodrv6

Direct Link to This Post

It's metric, 30mm.

------------------
Rod Schneider, Woodstock, Ga.
"You can't have too many toys!"
1988 Fiero GT
1966 Porsche 911
Van's RV-6 airplane-under construction

IP: Logged

jsantini
Member

Posts: 44
From: columbia, NJ, USA
Registered: May 2007

Feedback score: N/A
Leave feedback

Rate this member

Report this Post06-24-2007 09:36 PM

Send a Private Message to jsantini

Direct Link to This Post

Thanks a lot!

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock