Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Gauge cluster

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Gauge cluster by VFR182
Started on: 03-12-2007 09:56 AM
Replies: 1
Last post by: fieroluv on 03-12-2007 10:21 AM
VFR182
Member
Posts: 208
From: Central Kentucky
Registered: Sep 2006

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-12-2007 09:56 AM Click Here to See the Profile for VFR182Send a Private Message to VFR182Direct Link to This Post
My gauge cluster is super dim and in some cases no lights at all. Is this an easy repair to open it up and replace the bulbs (i assume its bulbs) any comment on improvements etc. thanks
IP: Logged
PFF
System Bot
fieroluv
Member
Posts: 1951
From: Ft Wayne, IN USA
Registered: Jul 2002

Feedback score: N/A
Leave feedback





Total ratings: 52
Rate this member
Report this Post03-12-2007 10:21 AM Click Here to See the Profile for fieroluvSend a Private Message to fieroluvDirect Link to This Post
doubt it is the bulbs. More likely a bad ground. I would check the connectors in the gauge cluster and see how the ground looks, and then trace the ground wire down to the mount point on the chassis and make sure it is secure.

edit to mention that the printed circuits on these things tend to wear pretty thin at times.

[This message has been edited by fieroluv (edited 03-12-2007).]

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock