I am trying to jump the ground to diagnostic terminal in the ALCL to run the codes on an '87 2.5 four cylinder engine. My manuals just say jump the A and B terminals. The block doesn't show A's, B's etc. When you go by their scematic, the B terminal is empty. Also there are only four wires in the ALCL : Orange, Black/White (ground ?), White/black, and Tan/White. My wiring diagram doesn't identify the diagnostic terminals. Can someone tell me which one to use? I anticipate that the black/white is ground. Thanks for the input. Ron
On one end there are two together. I believe they are the only two next to each other with one being on the end. If you jump the wrong two nothing bad will happen.
IP: Logged
11:46 PM
scorpion501 Member
Posts: 21 From: Loveland CO USA Registered: Aug 2004
Thanks TK. You are right. If I would have read page two of this section I would have seen the same question asked a week or so ago. Lots of good helpful information. Thanks again. Ron
