Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Vaccum dist.Do I loose my tach signal?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Vaccum dist.Do I loose my tach signal? by wet-buffalo
Started on: 03-27-2006 11:48 AM
Replies: 2
Last post by: 3800superfast on 03-28-2006 09:33 AM
wet-buffalo
Member
Posts: 33
From:
Registered: Jan 2006

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2006 11:48 AM Click Here to See the Profile for wet-buffaloSend a Private Message to wet-buffaloDirect Link to This Post
I'm changing over to a carb setup which means I'll be using a vaccum dist.
where do I get a tach signal now?
IP: Logged
PFF
System Bot
Tom Piantanida
Member
Posts: 527
From: Palo Alto, CA, USA
Registered: Oct 2004

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2006 01:46 PM Click Here to See the Profile for Tom PiantanidaSend a Private Message to Tom PiantanidaDirect Link to This Post
You should still be able to pick up the tach signal from the coil.
IP: Logged
3800superfast
Member
Posts: 8568
From: ohio U.S.
Registered: Apr 2004

Feedback score: N/A
Leave feedback





Total ratings: 191
Rate this member
Report this Post03-28-2006 09:33 AM Click Here to See the Profile for 3800superfastSend a Private Message to 3800superfastDirect Link to This Post
Hi, Welcome to the Forum , you could do as mentioned above, or ask OREIF he`s somewhere here on the forum..... Good Luck ...I think I`m going the same route on a 3.2 stroked.....
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock